1983 Ski-Doo Shop Manual, Page 183Get this manual
c Remove the bearings from the drive shaft using the fol lowing tools: hydraulic press ring (PIN 420977 480) plate (PIN 420 977 700)ring halves (PIN 420876330) -
SECTION 03 TRANSMISSION SUB-SECTION 08 (GEARBOX)
- Install the circiip over the bearingInstall the other componentsInstall the other shaft end bearing with shim(s) as required using the above mentioned tool- Available shims: 25.5340.2 (PIN 420944470) 25.5 34 0.3 (PIN 420 944 471) 25.534 0.5 (PN 420944472) Pla ce ball bearings with circiips mounted in the transmission housing and measure (A) distance between the bearingsMeasure (B) distance on drive shaft between the circlip (PIN 420945810) and the shaft bearing shoulder (key side) The difference between measures and should be 0.1 :1:: 0.3 mm (0003 :1:: .011 ")Refer to the following illustration
- hexagonal screws M8 25 (PIN 420 240 275)
IPress t:;j .JJ,Screws (2) Plate
Bearing shoulder