1983 Ski-Doo Shop Manual, Page 149Get this manual
SECTION 03 TRANSMISSION SUB-SECTION 03 (DRIVE PULLEY)
WARNING: Drive pulley repairs that include any disassembly or assembly procedures must be per formed by an authorized Bombardier dealer, or other such qualified personSub-component installation and assembly tolerances require strict adherence to procedures detailed
Remove spark plug(s) then bring P.T.Opiston at T.D.Cposition Rotate drive pulley 45 clockwise then insert enough starter rope into cylinder to fill it completelyRemove the capscrew
REMOVAL
Some pulley components are marked to insure proper assemblyIf components lack such marks, marking should be done manually before disassembly, as per illustration
If it is necessary to remove inner half, proceed as follows: On models Citation 4500 MISS, Mirage 111M, Nordik use metric threads puller (PIN 529 002 800PIN 529003000)On Skandic models use metric threads puller (PIN 529 002 800529 004 800)
INDEXING MARKS IN LINE
CAUTION: This pulley has metric threadsDo not use standard threads puller
On other models use standard thread puller (PIN 529 002 100)Remove starter rope blocking piston, then reblock piston after having turned 45 counter-clockwise from T.D .Cposition; or install crankshaft locking tool