1983 Ski-Doo Shop Manual, Page 147Get this manual
SECTION 03 TRANSMISSION SUB-SECTION 03 (DRIVE PULLEY)
INSTALLATION
Lock crankshaft in position as explained in removal procedureMake sure crankshaft is rotated 45 counterclockwise from T.D.Cposition and that cylinder is completely filled with starter rope
_ CAUTION: Ensure rollers are in good conditionReplace as required
CD Lubricate lightly pulley shaft with drive pulley lubricant PIN 413 800 700
Pack inside of pulley shaft with drive pulley lubricant PIN 413800 700
Position the capscrew then lube and torque to 61 N-m (45 ft -IbslWARNING: Shim(s) (3) is(are) used to obtain neutral function of the drive pulley when engine is idling Proceed as follows when retaining bolt is torqued: With new drive belt installed, you should be able to insert minimum of 0.80 mm (,030") thick feeler gauge on each side of the drive belt simultaneously when pushing drive belt to sit on bearing