1983 Ski-Doo Shop Manual, Page 127Get this manual
SECTION 02 ENGINE SUB-SECTION 08 (CARBURETOR AND FUEL PUMP)
INSTALLATION
To install carburetor(s) on engine, inverse removal procedureHowever, pay attention to the following:Apply thin layer of silicone sealant between carburetor rubber flange and intake cover on engine- Apply Loctite Lock'n Seal 242 on bolts retaining rubber flange to intake cover- When installing throttle cable end in throttle slide, hook up cable by using the stopper at the extremity of the cableBushing Jet needle
Rubber flange
Loctite ILock'n Seal 242)