1983 Ski-Doo Shop Manual, Page 121Get this manual
SECTION 02 ENGINE SUB-SECTION 07 (ENGINE TOLERANCES MEASUREMENT)
CONNECTING ROD BIG END AXIAL PLAY
TYPE MINIMUM MAXIMUM
- To correct position needle bearing and gudgeon pin on connecting rod then pry connecting rod as illustrated
247,277,377 503 464,534
0.201.00 mm (.008.039") 0.401.20 mm (,016 -047")
Using feeler gauge measure distance between thrust washer and crankshaft balancerIf the distance exceeds specified tolerance, repair or replace the crankshaft CONNECTING ROD ALIGNMENT
Check if connecting rod is bent as follows:Once engine crankcase is assembled with the piston mounted on connecting rod without its piston rings, position cylinder on piston
CRANKSHAFT END-PLAY247277 ENGINE TYPE
Specification:
MINIMUM MAXIMUM