1983 Ski-Doo Shop Manual, Page 116Get this manual
SECTION 02 ENGINE SUB-SECTION 06 (534 ENGINE TYPE)
CLEANING
Discard all seals and "0" ringsClean all metal components in non-ferrous metal cleaner
CAUTION: Ensure that the rotary valve shaft is perfectly perpendicular with the press tip or damage will occur
DISASSEMBLYASSEMBLY
(j) through Rotary valve shaft assembly
Clean rotary valve shaft and inside of distance sleeveAt assembly apply "Loctite 271" inside of distance sleeve
(j) At assembly, apply crankcase sealant "Loctite 515" on bearing and rotary valve shaft mating surfacesAt assembly apply lithium grease on seal lips
To remove rotary valve shaft assembly from crankcase, first remove coolant pump impeller and circlip Using the suitable pusher (PIN 420876610) and fiber hammer, push shaft assembly"Loctite 515" Tool no420876610