1983 Ski-Doo Shop Manual, Page 71Get this manual
SECTION 02 ENGINE SUB-SECTION 04 (464 ENGINE TYPE)
1Plug 2Plate (battery) 3Clip nut (2) 4Lockwasher 114 (2) 5Round slotted head machine screw 114-20 112 (2) 6Hexagonal elastic stop nut 114-20 (2) 7Coolant tank 8Bracket 9Hexagonal flanged elastic stop nut 74-20 (4) 10Clip (4) 11Hexagonal head cap screw M6 1.00 16 (2) 12Hexagonal elastic stop nut 1.00 (2) 13Pressure cap 14Overflow hose 16" (406 mm) 15Hose 23" (584 mm)
16171879202722232425262728
Gear clamp (2) Clip Inlet hose Gear clamp (6) Heat exchanger (2) Radiator protector (2) Hexagonal washer head self-tapping screw 10-24 112 (2) Rivet (42) "U" hose Outlet hose Grommet Thermostat Sensor
INSPECTION
Check general condition of hoses and clamp tightness
REFILLING THE SYSTEM
Capacity: Approximately liters (1.1 Impgal (1.3 U.Sgal 60 antifreeze40 water CAUTION: Always use ethylene-glycol anti-freeze "containing corrosion inhibitors specifically recommended for aluminum enginesTo refill the cooling system, unscrew the plug on top of the cylinder head, then slowly pour the liquid into the coolant tank until it reaches the plug hole in the cylinder head Reinstall the plugContinue to pour the liquid in the coolant tank until the coolant level reaches 25 mm (1 ") below filler neck of reservoir