1983 Ski-Doo Shop Manual, Page 69Get this manual
SECTION 02 ENGINE SUB-SECTION 04 (464 ENGINE TYPE)
To pass new coil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube Insert the new wires into the old connector housing and install connectors
CAUTION: Protect harness from flame
Remove screws (use Phillips no2 or suitable flat screwdriver) Pull out protector tubes and unsolder the splice connectors Solder the two yellow wires in the harness to the leads of the lighting coil
Insert new wires -
Position protector tube over connectionTie wires to the coil as illustrated
_ CAUTION: Replace the old wires in the connector with th same color coded new wiresInstall new receptacle connector to the redblack striped wire
CD Prior to assembly, apply "Loctite 242" (blue, medium strength)
_ CAUTION: Before reinstalling magneto remove the loose epoxy from harness
ASSEMBLY
Clean crankshaft extension taper Apply "Loctite 242" (blue, medium strength) on taper Position key and magneto housing on crankshaft