1982 Ski-Doo Shop Manual, Page 327Get this manual
SECTION 05 SUSPENSION SUB-SECTION 04 (DRIVE AXLE)
ASSEMBLY
NOTE: 1982 models have two different axle-sprocket press fitsEnsure to replace ring reinforced sprockets with the same type
_ CAUTION: The same sprocket must not be pressedtwice on the axleIf synchronization is found to be defective, use new sprocket
NOTE: Idler wheel G) must turn freely
To assemble press fit sprockets, use press and pipe (1 18 1.0 as illustratedSprockets must be assembled with the following dimensions
Tightening torque for axle flanges is 3-4 N-m