1982 Ski-Doo Shop Manual, Page 303Get this manual
SECTION 05 SUSPENSION SUB-SECTION 01 (BOGIE WHEELS)
REMOVAL
Raise and block rear of vehicle off the groundRelease track tension by unlocking the link plate springs using an appropriate tool
DISASSEMBLYASSEMBLY
CD Heat wheel support anchor before attempting to open or close anchor
Clean, then lubricate cross shaft with low temperature grease before installation
Always pull or push bearing by inner raceWhen in stalling bearing on wheel support, position bearing shield towards inner flange, then press down until bearing is sitting flush with support end
Starting at center bogie wheel set, remove bolts and lock washers securing cross shaft to frameNOTE: To prevent the cross shaft from rotating within the cross support, wedge screwdriver blade between the cross shaft and cross support