1982 Ski-Doo Shop Manual, Page 282Get this manual
SECTION 04 ELECTRICAL SUB-SECTION 06 (ELECTRIC STARTER)
For assembly, follow the disassembly procedure in the reverse order, paying attention to the followingCoat the sliding surfaces and moving portions of the armature splines, overrunning clutch, bushings and the solenoid switch plunger with mUltipurpose grease (water, climate and coldness resistant)Reinstall the drive lever as illustrated below
CLEANING
_ CAUTION: Armature starter yoke ass'y and drive unit assembly must not be immersed in cleaning solvent, Clean brushes and holders with clean cloth soaked in solventBrushes must be dried thoroughly with clean clothBlow brush holders clean using compressed air Remove dirtoil or grease from commutator using clean cloth soaked in suitable solventDry well using clean, dry cloth Clean engine starter gear teeth and drive unit (clutch)
Drive lever Overrunning clutch
NOTE: Bearing bushing of the drive unit must not be cleaned with grease dissolving agents
Immerse all metal components in cleaning solution Dry using clean, dry cloth