1982 Ski-Doo Shop Manual, Page 242Get this manual
SECTION 03 TRANSMISSION SUB-SECTION 08 (GEARBOX)
Remove the bearings from the drive shaft using the following tools: hydraulic press ring (PIN 420 977 480)ring halves (PIN 420 876 330)plate (PIN 420 977 700)hexagonal screws M8 25 (PIN 420 240 275)
- Install the circlip over the bearing- Install the other components- Install the other shaft end bearing with shim(s) as required using the above mentioned tool- Available shims:
25.5340.2 (PIN 420 944 470) 25.5340.3 (PIN 420 944 471) 25.5340.5 (PIN 420 944 472)
Place ball bearings with circlips mounted in the transmission housing and measure (A) distance between the bearings
Measure (8) distance on drive shaft between the circlip (PIN 420 945 810) and the shaft bearing shoulder (key side)The difference between measures and should be 0.10.3 mm (0.003.011 ")Refer to the following illustration
Keyside
Bearing shoulder
Circlip (PIN 420945810)
Circlip