1982 Ski-Doo Shop Manual, Page 174Get this manual
SECTION 02 ENGINE SUB-SECTION 11 (REWIND STARTER)
REMOVAL
Remove bolts and washers securing rewind starter to engine, then remove rewind starterNOTE: On some models the hood requires supporting before removing starter housingThe retaining cable is attached to one of the rewind starter attaching bolts
Outer end into guide notch
On oil injection models, remove oil injection pump from rewind starter cover
DISASSEMBLY
remove rope from rewind starter mechanism:First remove lock ring, lock spring, circiip, pawl lock and pawl- Remove sheave from starter housing- Disengage key and pullout rope
Lubricate spring assembly with low temperature grease PIN 413 7039 00 and position into starter housing as illustrated