1982 Ski-Doo Shop Manual, Page 152Get this manual
SECTION 02 ENGINE SUB-SECTION 09 (CARBURETOR AND FUEL PUMP)
INSTALLATION
To install carburetor(s) on engine, inverse removal procedureHowever, pay attention to the following:Apply thin layer of silicone sealant between carbu retor rubber flange and intake cover on engineApply Loctite Lock'n Seal 242 on bolts retaining rub ber flange to intake cover- When installing throttle cable end in throttle slide, hook up cable by using the stopper at the extremity of the cableBu shing Jet needle
'-Rubber flange
Silicone
Locllte ILock'n Seal 242)
Make sure the bushing is installed on all applicable throttle sl idesCAUTION: Serious engine damage can occur if this notice is disregarded