1982 Ski-Doo Shop Manual, Page 147Get this manual
SECTION 02 ENGINE SUB-SECTION 08 (ENGINE TOLERANCES MEASUREMENT)
CRANKSHAFT END-PLAY640 ENGINE TYPE
Specification:
MINIMUM MAXIMUM 0.20 mm L008") OAO mm LOW")
- Measure distance between bearing simulator and retaining washer
Bearing simulator
ADJUSTMENT:
eCrankshaft end -play is adjusted with shims located between crankshaft and magneto side bearing CAUTION: Always reinstall end-play adjustment shim(s) on the magneto side between bearing and crankshaft bladeThe following is required for the adjustment procedure:adjustment shims (refer to parts catalog) (thickness available)