1981 Ski-Doo Shop Manual Supplement, Page 114Get this manual
r- From the left side of vehicle, place the drive axle within the trackPush the end bearing side of axle through the orifice in left side of frame, then push the splined end of axle into gearbox lower sprocket Install opposite drive axlePress each end bearing housing into frame and over axle bearing Secure housings to frame Install oil sealsNOTE: gap of approximately 1.6 mm (116") should exist between the end of bearing housing and oil seal
SECTION 05 SUB-SECTION 08 (GEARBOX)
Bearing
b7777Trr