1980 Ski-Doo Shop Manual, Page 297Get this manual
SECTION 06 SUB-SECTION 02 (SLIDE SUSPENSION)
DISASSEMBLYASSEMBLY
00To replace worn slider shoeremove the rear spirol pinSlide the shoe rearwards out of the runner00To remove the rivets securing the adjustment plate on the front arm supportscut off the rivet heads using cold chiselAt assemblyposition the rivet head on suitable metal bloc and hold the assembly firmly in placeWith flat head punch and hammer secure the rivet in placeAt assemblyadjustment cam must be installed that hexagonal projection on cam is located toward front of vehicle-Front
LOW POSITION
HIGH POSITION
Flat head punch
Sliding support must be installed with offset toward front
Metal block