1980 Ski-Doo Shop Manual, Page 262Get this manual
SECTION 05 SUB-SECTION 05 (PULLEY ALIGNMENT) -
Bend the tab lock of the adjuster nut
- Adjust the offset by adding or removing shimsWith6" shim In placepush assembly in against bearing plate
, CAUTION: Make sure the lock tab is secure inthe driven pulley keyway
1161 Shim
Everest, Futura, Blizzard 5500, 7500, 9500, Grand Prix Special, Super Sonic, Ultra Sonic
OFFSET34 mm (1 1132")Floating type driven pulley requires special procedure to correctly measure offsetInstall 116" gauge between pulley and bearing plate
NOTE: To add or remove shimspulley assembly must be removed as per driven pulley removal procedure
- Then measure offset (usual method)IMPORTANT: Make sure driven pulley assembly is fully seated against bearing flange when measuring offsetNominal distance between pulleys