1980 Ski-Doo Shop Manual, Page 184Get this manual
SECTION 03 SUB-SECTION 06, (REWIND STARTER)
REMOVAL
Remove bolts and washers securing rewind starter to engine, then remove rewind starter
While holding sheave under tension, fat ate sheave until the starter hOUSing orifice and sheave orifice alignInsert rope through both onfices until rope is visible In the key clamp housing, to lock the rope
NOTE: On some models, the hood requires supportIng before removing starter housingThe retaining cable IS attached to one of the rewind starter .8ttachlng bolts,
Position the key clamp In ItS housing then push In
On oil Injection models, remove oil injection pump from rewind starter cover
00At assembly, position spring outer end Into spring gUide notch then wind the spring clockwise Into guideWARNING: Since the spring is tightly wound inside the guide it may fly out when the guide is manipulated, Always handle with care,
DISASSEMBLYASSEMBLY
Prior to installing starter grip on new rope, it IS first necessary to fuse the rope end with lit matchPass rope through starter gnp, and tie knot In the rope endFuse the knot with lit match then turn the knot down and pull the starter grip over the knot