1980 Ski-Doo Shop Manual, Page 48Get this manual
SECTION 03 SUB-SECTION 02 (ENGINES)
MAGNETO AND COOLING SYSTEM CLEANING
Clean all metal components in non-ferrous metal cleanerCAUTION: Clean armature using only clean cloth
DISASSEMBLYASSEMBLY
o To replace condenser, it is first necessary to discontinue the two (2) black leads uSing soldering IronThe condenser can then be driven out of the armature plate using suitable pusherTo reinstall, inverse procedureWhen replacing contact breakerapply light coat of grease on lubricating wick
NOTE: It should be noted that to correctly remove "Loctite" locked screw, it is first necessary to tap on head of screw to break Loctite bondThis will eliminate the possibility of screw breakage
Hold-on support
0 Whenever
a call is replacedthe air gap (dlsstance between magnet and call end) must be adjusted