1978 Ski-Doo Shop Manual, Page 331Get this manual
-l SECTION 06 SUB-SECTION 01,(CAB)
- Peel off protective film from the new windshield and install windshield trimInsert anchor tabs into holes of windshieldInstall tabs in every retaining holes at the exception of the front center holeBend each tab in the middle until ends meetLubricate rubber strip with liquid soapInstall strip into cab channelPosition windshield in cab channel then from within the cab, pull and fully open anchor tabsWork from center, outwardRubber strip
Olympique, Everest, Futura, Everest 444, Futura 444, TNT, Blizzard, Sonic
- Peel off protective film from the new windshield- Position windshield on cab then push down until tabs are locked in their holes- Install windshield trim on outer edge
- Peel off protective film from the new windshieldPosition windshield on cab then push until tabs are fully inserted into cab slotsLock windshield tabs in position using the four (4) "0" rings supplied in kit- Using the windshield holes as guide, drill 732" diaholes through cabInstall the two (2') retaining bolts and the two (2) push nuts- Install windshield trim on outer edge