1978 Ski-Doo Shop Manual, Page 239Get this manual
SECTION 04 SUB-SECTION 05, (CARBURETOR)
INSTALLATION
To install carburetortsl on engine, inverse removal procedureHowever, pay attention to the following:Apply thin layer of silicone sealant between carburetor rubber flange and intake cover on engine- Apply Loctite Lock'n Seal 242 on bolts retaining rubber flange to intake cover- When installing throttle cable end in throttle slide, hook up cable by using the stopper at the extremity of the cableCable adjuster
Throttle cable end
Air screw adjustment
Completely close the air screw until slight seating resistance is felt then back off to specifications in Technical data