1978 Ski-Doo Shop Manual, Page 219Get this manual
SECTION 04 SUB-SECTION 03, (REWIND STARTER)
rope from rewind starter mechanism, fully extend rope and hold rope sheave in positionThen using pointed tool, disengage key clamp and pull rope free
o To remove
Hub notch Push out to disengage rope Key clamp
To install rope, proceed as follow:Rotate sheave counter-clockwise six (6) turns to achieve correct recoil tensionHold in position- While holding sheave under tension, rotate sheave until the starter housing orifice and sheave orifice align- Insert rope through both orifices until rope is visible in the key clamp housing- Position the key clamp in its housing then push in to lock the rope
Plastic rope sheaves and metal rope sheaves are interchangeableHowever it is recommended to use the appropriate screws with plastic rope sheavesPosition pawls, springs and spring stops on pivoting arm as illustrated
Chamfer