1978 Ski-Doo Shop Manual, Page 14Get this manual
SECTION 01 SUB-SECTION 02 (SLIDE SUSPENSION)
DISASSEMBLYASSEMBLY
0000To replace worn slide shoe, remove nut and bolt securing front of shoe to runner, and remove rear spirol pinSlide shoe rearwards out of runner000To remove rivets securing adjustment plate or front arm supports, cut rivet head using chiselAt assembly, rest rivet head on suitable metal block and hold ass'y firmlyUsing flat head punch and hammer secure rivet
Center ball bearing on rear axle has slightly larger inside diameter, i.e25.37 mm (,999") instead of 24.99 mm (,984")Front armElan, Olympique and Nuvik Elite
Citation 300 Flat head punch
Everest and Futura
Metal block'