1974 Ski-Doo Shop Manual, Page 125Get this manual
REMOVAL Remove the four (4) bolts and washers securing rewind starter to engine, then remove
- Insert rope through both orifices until inch of rope is visible in the key clamp housing- Position the key clamp in its housing then push in to lock the rope To open spring cartridge, screwdriver as pryuse thin
Note: On some models, the cab needs support(The retaining cable is attached to one of the rewind starter attaching bolt)
DISASSEMBLYASSEMBLY
0 Prior to installing starter, grip on new rope, it is fi rst necessa ry to fuse the rope end with Iite matchPass rope through starter grip, and tie knot in the rope endFuse the knot with lite match then turn the knot down and pull the starter grip over the knot
W arningSince the sprillg is tightly wound inside the ca rtridge it may fly out when the cartridge is openedAt assembly, position spring outer end into spring cartridge guide notch then wind the spring counterclockwise into guide