1974 Ski-Doo Shop Manual, Page 88Get this manual
Po sition cylinder head on cylinder with fins in line with crankshaft ce nter lineCross torque retaining nut to 14-16 ft -Ibs Tab washer should be replaced if bent more than three (3) timesIf in doubt, replaceAt assembly, torque to 14-16 ft -Ibs0 At assembly, apply small amount of grease into spring seating)To replace capacitor, it is first necessary to discon nect the two (2) black leads using soldering ironThe capacitor can then be driven out of the armature plate using suitable driftTo reinstall, inverse procedure Magneto
With magneto retaining nut removed and hold -on support in place, install special puller onto hubTighten puller nut and at same time, tap on nut head using hammer to release magneto from its taper