1972 Ski-Doo Shop Manual, Page 231Get this manual
BODYFRAME 4-0103
2Turn adjusting screw counter-clockwise to raise beam(C) On vehicles equipped with fixed headlamp, beam adjustment is as follows;
1Loosen two (2) screws securing head lamp to cab
2Place wedge between the top of the chrome ring and the cab to lower beam
3Place wedge between bottom of chrome
ring and cab to raise the beam
4Tighten headlamp screwsA AdjustlnlllCTew
(D) Side Deflection (All vehicles except Nordic) 1On vehicles with expose head lampretractable headlamp, ter
NOTE: If the adjuster screw is at its maximum and does not correct the beam height, remove the control rod from the control leverRotate the turnbuckle clockwise to lower the beamor counter-clockwise to raise the beamConnect control rod to control lever (fig4-1-8)
2Disconnect receptacle housing from minals of headlamp socket