1972 Ski-Doo Shop Manual, Page 110Get this manual
STEERING SYSTEM 7Lift the ball bushing from the steering channel and remove the steering column from vehicle8Remove cotter pin, washer and spring affixing the transmiSSion rod to gear change leverDisengage the rod from the lever9Disconnect all electrical connections and switch blocks at dash panel1ORemove the brake and throttle cables from dash panel by passing them through appropriate orifice or anchor of panelTie rod end
1-15-09 2Unscrew the tie rod ends from the tie rods (fig1-15-17)
11Remove the tour (4) nuts and cable bracket attaching dash .panel to upper col,mn and remove the dash panel and brackets from vehicle12Remove cotter pin affixing transmission rod to dash panel bracket and disengage the rod from the bracket (fig1-15-16)
NOTE: The tie rod end attached to the steering column incorporates left hand threads"while the tie rod end attached to the steering arms has right hand threads3Remove the tie rod end locknutsDISASSEMBLY (OlympiqueT'NT Models) NOTE: On T'NT models, tab locks have to be released before removing bolts or nuts1Remove nuts securing tie rod assembly to steering column bracket and remove tie rodsOn T'NT models.remove tab locks (fig115-18)