1972 Ski-Doo Shop Manual, Page 21Get this manual
1-02-06 facing towards inner flange, then press down on the inner race until bearing is sitting flush(fig1-2-15)SLIDE SUSPENSION
8Using rivet gun, secure the stop bondings
to rear cross support (fig1-2-17)
Stop bonding
Runner tube
9Insert sleeves in arms of cross supportsSecu re cross supports to sliders by means of bolts and nutsSlide the three (3) rear supports onto the sliding pads10I nsert sleeves and then bolt front support to front runner tube11Connect rear and front runner tubes with clevis pins and cotter pins12Apply light coat of low temperature grease on cross shafts and insert shafts into cross supports13Position suspension springs and close the cross support anchors over the spring endsSecu re the side members using washers and cap screws (fig1-2-18)