1972 Ski-Doo Shop Manual, Page 18Get this manual
SLIDE SUSPENSiON
4Using 18 inch dia drill, remove the rivets attaching the stop bondings to the rear cross support (fig- 1.2-(6)
114732" Drill
NOTE: If head of rivets securing slider shoe to runner tube is flush with contact surface, shoe is excessively worn and must be discarded and replaced during Assembly procedure5Remove bolts securing sliders to support and remove the sleeves6Remove bolts securing front cross support to front runner tube (fig1-2-7)
DISASSEMBLY (Olympique 300 Models)
1Remove capscrews and star washers secu ring side members to cross shaftsHeat support anchors then straightenRemove eight (8) sus pension springs and pull out the cross shafts from cross supports (fig1-2-5)NOTE: To prevent the cross shafts from rotating within the cross supports, wedge screwdriver blade between the cross shaft and cross support