2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 368Get this manual
Chassis 8Remove the tie rod bootRemove the idler arm bolt and nutNOTE: Left side shown
PROPANE GAS TORCH
9When all of the noted fasteners and nuts are removed, the next step is to heat where the bulkhead clip mates with the engine side support brace10Wearing heat resistant gloves, use propane gas torch to heat the adhesive between the two componentsApply torch until adhesive begins to crackleDuring this time, the adhesive may smoke and bubbleContinue heating the area until the components can be separated