2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 359Get this manual
Chassis 3While holding the mixer needle over piece of scrap material, slowly compress the caulk gun trigger to fill the mixer needleThe needle will automatically mix and dispense the correct volumetric ratio of adhesive and accelerator
Adhesive Application Patterns
Reference the following illustrations showing the exact patterns for each bonded component when applying the adhesiveBULKHEAD FLOOR
ADHESIVE LINE
4Continue squeezing the trigger until needle's length of adhesive is expelled5Quickly apply 4mm bead of adhesive to the component as shown on the following pagesApply adhesive to one component at time6Carefully install the component and torque the fasteners to specification immediatelyDo not break the bond once the components are mated
LH (PTO) SIDE BRACE (BULKHEAD MATING SURFACE)