2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 294Get this manual
Steering and Suspensions Toe Adjustment
Toe is adjusted with the shocks and skis installedTrack alignment must be correct before starting this processToe alignment is measured at ride height1Rock the front end of the vehicle up and down and then set it down gentlyThis will set the front suspension at ride height2Verify the handlebars are centeredMeasure from each end to common center point at the rear of the snowmobile to verify3Measure and make mark 10" (2.54cm) forward of the ski mount bolt and 10" (2.54cm) behind the ski mount bolt, preferably on the center line of the carbide skags10Turn both tie rods equally to set ski toeWhen finished, measurement (X) should be 0"18" wider than measurement (Y)11Torque steering tie rod jam nuts to specification and lower the vehicle
4Place straight edge along the one side of the trackMake sure that the straight edge is touching along the length of the track5Record the measurements from the edge of the straight edge to the forward ski mark (X) and the rearward ski mark (Y)6Adjust the tie rod so that both measurements are the same7Place the straight edge on the opposite side of the track and measure the opposite ski marks8Adjust the tie rod so that both measurements are the same9Steps to will align the skis with the trackAt this point, verify the handlebar is centered with the skisNOTE: The handlebar can be aligned with the skis on models featuring an adjustable drag link by adjusting the length of the drag linkIf the snowmobile does not feature an adjustable drag link, handlebar-ski alignment can only be performed by adjusting the steering tie rod lengths