2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 240Get this manual
PVT System Team LWT Components
SCREWS ROLLER ASSEMBLY HELIX SNAP RING SPRING CUP SPRING DEFLECTION SPACER STATIONARY SHEEVE
MOVEABLE SHEEVE BELT DEFLECTION SCREW
Helix Fasteners: 60-80 in-lb (7-9 Nm) Driven Clutch Retaining Fastener: 17 ft-lb (23 Nm) Disassembly and Assembly Process 1Remove the screws from the helix, then carefully pry the helix out of the moveable sheave, or gently tap shaft on block of wood2Install the clutch in the clutch compressor fixture, PN 8700220Install the extensions, PN PS-45909
double splines on the shaftSlowly compress the spring and roller assembly down on to the shaftInstall the snap ring making sure it is fully seated in the groove9Install the helix by aligning the rollers with the rampsPush the helix down into the sheave while keeping the screws holes aligned10Install and torque helix fasteners to specification