2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 211Get this manual
Final DriveBrake System 5Position the caliper over the steel plate with the plate firmly against one of the retracted pistons12Coat the piston thoroughly with new brake fluidEvenly insert each piston into the bores, working each in by hand carefully and slowlyPush each piston down until bottomed out13Reinstall the brake caliper on to the chaincaseTorque fasteners to specification
CAUTION
DO NOT PUSH ON THE CALIBER BORE PLUGDOING SO WILL BREAK THE PLUG SEAL AND REQUIRE CALIPER REPLACEMENT
Caliper Mounting Screws: 18-20 ft-lb (24-27 Nm) 14Inspect both brake pads prior to installationIf they are within the pad wear specification, reinstall into caliper15Install the brake hose using the same routing and orientation noted during removalTorque fitting to specification