2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 200Get this manual
Final DriveBrake System Mounting Assembly View
Stud Plate-RMK Models Only Tunnel Reinforcement Plate-Switchback Only
Align with bulkhead cooler4 B
C 3Remove the fasteners securing the chaincase to the tunnel, front coolercloseoff panel, and side support4Inspect the seals for excessive wear or damageReplace as required5Verify bearings roll smoothlyReplace if they do not or if excessive play is evidentUse an arbor press to remove and install bearings6To install the chaincase, loosely install all of the fasteners using new lock nuts where applicable7Verify fastener (1) is installed in the lower chaincase mounting hole has shown in the illustration8Torque fasteners to specifications
NOTE: 2012 Pro-Ride models feature bonded chaincaseREFERENCE