2010-2012 PRO-RIDE RUSH Switchback RMK Service Manual, Page 183Get this manual
Cleanfire Fuel Injection BASE AND IDLE SETTING
CAUTION
The throttle position sensor (TPS) is set at the time of throttle body manufactureTPS adjustments should only be made if the TPS was loosened, repositioned, or replacedAny adjustments made to the idle air gap screw, TPS sensor, or throttle synchronization screw should only be performed when directed to so by the Digital Wrench Diagnostic SoftwareAccess the Base and Idle Setting procedure when repairing loose TPS sensor, or when replacing the sensor with new partNOTE: New throttle body service parts include the TPS sensor and are set at the time of manufactureDo not perform the Base and Idle Setting procedureDigital Wrench will guide the technician through the process of establishing the TPS baseline voltage and TPS idle voltage settingsNOTE: Test vehicle after performing repairingreplacing TPS sensor and after completing base and idle setting procedure to verify proper vehicle operationFULL PROCEDURE (Synchronization)