2007 Polaris Two Stroke Snowmobile Workshop Repair manual, Page 267Get this manual
BATTERYELECTRICAL SYSTEMS THROTTLE POSITION SENSOR (TPS)
The following models use throttle position sensor (TPS): 500 XC SP 600 HO Carbureted (All Models) 600 HO CFI (All Models) 700 HO CFI (All Models) The TPS is located on the carburetor rack (carbureted engines) or on the throttle body (CFI engines)The TPS is set at the time of manufacture and should only require adjustment when: When the TPS is replaced When the carburetor rack or throttle body is replaced or adjusted The TPS is suspected of being set incorrectly as part of troubleshootingThe TPS test tool, PN 2201519, is used to accurately adjust the TPS return signal settings3Connect the test tool to the TPS on the carburetor or throttle body
NOTE: Always disconnect the volt battery when tool is not in use
Using the TPS Test Tool
1234Remove the wiring harness connector from the TPSVerify the throttle cable is not kinked and the throttle flipper is closedConnect the test tool to the TPSInsert the black multimeter probe into the black terminal port, then insert the red multimeter probe into the yellow terminal portReference the specifications to determine if the TPS requires adjustment or replacement