2007 Polaris Two Stroke Snowmobile Workshop Repair manual, Page 209Get this manual
FRONT SUSPENSIONSTEERING Rod End
Rod ends must be parallel to their respective mounting surface after tightening jam nutHold the rod end and tighten jam nutIf possible, support the edge of the rod end to keep it from rotating out of position until jam nut is tightWhen rod ends are properly tightened, the rod should rotate freely approximately 1 turn
ALIGNMENT ADJUSTMENTS
Alignment adjustments should be preformed in this order
EdgeEdge LXEdge RMK Set Up Width
Prior to performing steering alignment, the suspension should be inspected for damage or wear and replacement parts installed as requiredIMPORTANT: Camber, width are dimensions that depend on each otherIf any adjustments have been made, each one should be checked
Rod End Engagement
Rod ends must engage the rod minimum of 2x the thread diameter when adjustment is completeExample: .4375" (11mm) rod end (A)minimum thread engagement (B) .875" (22mm)