2007 Polaris Two Stroke Snowmobile Workshop Repair manual, Page 203Get this manual
FRONT SUSPENSIONSTEERING If the suspension is "bottoming" tighten the compression screw clockwise in 12 turn increments until the bottoming stopsBacking off 14 turn counter-clockwise at this point should give you the best possible ride ensuring use of the full travel of the suspensionThe opposite procedure should be used if the suspension is too stiff upon initial set-upIf bottoming continues after the screw is turned in full clockwise, the compression spring should be adjusted with the threaded adjustment collarBack the screw out to the original starting position after the compression spring has been adjustedRiding conditions are ever changingKeep in mind the compression damping adjustable screw can be adjusted at any time to achieve the best possible ride in any conditionNOTE: Whenever shocks are replaced or reinstalled for any reason, the adjustment screw should be located toward the inside of the suspensionAccess to the adjuster is not possible if installed differently