2007 Polaris Two Stroke Snowmobile Workshop Repair manual, Page 129Get this manual
ENGINE 4Install the oil supply line through the guide (2) on the MAG intake9Insert the front engine strap washer and Nyloc nut (7) onto the motor mount stud and torque to 28 ft-lb (38 N-m)10Adjust the front torque stop so that the bumper is bottomed out on the plate, and lock the lock nut11Insert the front isolator limiter assembly (8) and torque the fasteners (9) to 28 ft-lb (38 N-m)See "Engine Isolator Limiter Setting" on page 3.22
Place the engine into the bulk head and make sure that it is lined up with the motor mountsInsert the LH rear torque stop plate (3) between the motor mount and the bulk headApply blue Loctite to the fastener (4) and torque all the outside fasteners (4,5) to 28 ft-lb(38 N-m)