2007-2011 Polaris IQ Snowmobiles Service Manual, Page 432Get this manual
Shocks 12Set the IFP so it is approximately 18 from the bottom of the reservoirInstall the bleed screw(IFP) from its original positionPerformance issues will be result if the IFP is not in its specified position16Tighten the cylinder head onto the shock body17Verify the IFP is set at the specified depthIf not, verify there is oil on top of the IFP, then open the bleed screw18Set the IFP to specification, then close the bleed screw19Pour out any remaining shock oil from the reservoir20Install the cap making sure the o-ring does not flipoverInstall the snap ring21Charge the shock to the specified pressure22Clean the shock of all oil reside and check for any leaks23Install button screw onto the reservoir cap13With the cylinder head assembly pushed down against the valve piston, dip the piston assembly in shock oil
Ryde FX Remote Reservoir Shock Disassembly
1Remove the bushings and eyelet components from the lower shock bodyMount the shock in softjawed bench vise