2007-2011 Polaris IQ Snowmobiles Service Manual, Page 327Get this manual
PVT System PVT SYSTEM ADJUSTMENTS
Clutch AlignmentOffset
The drive and driven clutches are offest from each otherThis offset is controlled by the number and thickness of washers installed on the jackshaft behind the driven clutch1Remove drive belt2Push the driven clutch towards the bulkheadInstall the correct alignment tool depending on the type of driven clutch installed on the snowmobileTOOL PART NUMBER APPLICATION
Driven Clutch OffsetShim Washers
Offset Washers 16 GABushing =7556509 .023"7555917 .120"7555864 Float Washers .063"7555734 .047"7555957
CAUTION
Always verify the driven clutch floats on the jackshaftThe jackshaft bearing will fail from side-loading if the driven clutch is not allowed to float
PS-46998 PS-47477