2007-2011 Polaris IQ Snowmobiles Service Manual, Page 312Get this manual
Final Drive and Brakes 4Hold the caliper over the brake fluid jar and then push the pistons back into the caliperThis will push the brake fluid in the caliper out of the brake hose banjo fitting hole5Clamp the end of 14" thick 2" 10" piece of steel to the workbenchAllow the piece of steel to hang off of the bench by5"6Position the caliper over the steel plate with the plate firmly against one of the retracted pistons14Reinstall the brake caliper on to the chaincaseTorque fasteners to specification
Caliper Mounting Screws: 18-20 ft-lb (24-27 N-m) 15Inspect both brake pads prior to installationIf they are within the pad wear specification, reinstall into caliper16Install the brake hose using the same routing and orientation noted during removalTorque fitting to specification
CAUTION
DO NOT PUSH ON THE CALIBER BORE PLUGDOING SO WILL BREAK THE PLUG SEAL AND REQUIRE CALIPER REPLACEMENT