2007-2011 Polaris IQ Snowmobiles Service Manual, Page 273Get this manual
Engine and Cooling Systems 18Place the engine mount washers and fasteners (8) onto the engine mount studsTorque to specification21Adjust the rear torque stop so that you have clearance of .010"-.030" (.25-.75mm) from the face of the torque stop to the surface of the engine
= In mmRear Torque Stop Clearance: .010"-.030" (.25-.75mm) NOTE: If new torque stop is installed, install it so that the nub is touching the engineThis nub is .030" (.75mm) long22Adjust the engine isolator limiter (if equipped) so the stop is bottomed out on the brace
Engine Mount Fasteners: 28 ft.lb (37.9 N-m) 19Install the right hand chassis brace
Stop touching base 23Install the front torque stop assembly and torque the plate fasteners to specification