2007-2011 Polaris IQ Snowmobiles Service Manual, Page 154Get this manual
Maintenance Track Alignment
NOTE: Track alignment affects track tensionMisalignment of the track will cause excessive wear to the track, rail slides, and railNOTE: Excessive rail slide wear occurs due to running in inadequate snow conditionsPeriodically check that the track is centered and running evenly on the slide railsMisalignment will cause excessive wear to the track and slide rails1Safely lift and support the rear of the snowmobile off the ground2Rotate the track by hand to check for any possible damage3Inspect the track rods (A) carefully and examine the track along the entire length of each rod, bending the track edge and inspecting it for breakageIf any rod damage is found, the track should be replaced4Warm up the track by starting the engine and apply small amount of throttle so the track runs slowly at least five complete revolutions5Stop the engine and turn the ignition off6Inspect track alignment by carefully looking through the track window (B) to make sure the rails (C) are evenly spaced on each side7If the track runs to the left, loosen the left locknut and tighten the left adjusting bolt (D)If the track runs to the right, loosen the right locknut and tighten the right adjusting boltIt may be necessary to check this with the engine rotating the trackBe sure to SHUT THE MACHINE OFF before making any further adjustments