2007-2008 Polaris IQ Snowmobiles Service Manual, Page 304Get this manual
Battery and Electrical Systems NOTE: If the engine stops running or is shut off while in reverseThe engine will start in forward gearfast flash indicates the system is set up for high elevationPush and hold the reverse button for longer than seconds to toggle back and forth from high and low elevation settingsOn Cleanfire units this is automatically done through the engine controller unit (ECU) Elevation above 6000 ft (1829m) requires different timing curve to eliminate "kick-back" effect If engine is shut off or dies in forward or reverse gear, the engine when started will automatically be in forward gear When servicing clutches, ensure that the vehicle is in the forward gear
FORWARD OPERATION
1If unit was operated in reverse, ensure that the path ahead is clear, and push an hold the reverse button for second and then release the buttonThe engine will now automatically change direction form reverse to forward and the reverse light on the instrument panel will stop flashingNOTE: When servicing clutches, ensure that the vehicle is in forward gearIf not damage to the driven clutch may occur when removing the belt