2007-2008 Polaris IQ Snowmobiles Service Manual, Page 214Get this manual
Steering and Suspensions Rod Ends
Rod ends must be parallel to their respective mounting surface after tightening jam nutIf possible, support the edge of the rod end to keep it from rotating out of position until jam nut is tightWhen rod ends are properly tightened, the rod should rotate freely approximately 18 turn3Determine which spindle requires the greatest amount of correction my installing the alignment bar through one spindle to the other spindleMeasure the distance from the top of the alignment bar to the top of the ski mount hole with the bushing(s) removedRecord measurementRemove the alignment bar and install it to measure the opposite sideMeasure the distance from the top of the alignment bar to the top of the ski mount hole with the bushing(s) removedRecord measurement To adjust the camber, unlock the lock nut and adjust the camber with the adjuster nut until alignment bar measurement is within the specified range for each spindleOnce the specification is achieved, tighten all jam nut(s) and torque them Ft.Lb(61 Nm)Re-check the set up width and compare to specificationRod End Engagement