2004 Polaris Touring Service Manual, Page 193Get this manual
BODYSTEERING Toe Adjustment- Edge
1Remove alignment bar from spindles2Toe alignment is set with shocks installed on Edge3Install skis4Adjust toe so skiscarbides are parallelzero toe out or toe in with toe alignment travel bar installedMeasure from equal point on skag centerline to straightedge to determine the amount of adjustment required per skiMeasuring from points on skis may vary and should not be used
NOTE: Measurements A&B should be equal and taken 10 (254 mm) fore and aft of spindle center as shown with toe alignment travel bars installed10