2004 Polaris Touring Service Manual, Page 154Get this manual
CLUTCHES Removal
CAUTION:Wear eye protection during disassembly and assembly of driven clutch1Hold clutch with Clutch Holding Wrench (PN 931477A)Remove drive clutch retaining bolt, grease puller thread and tip lightly and install correct puller into clutchTighten the puller with wrenchWhen tight strike t-bar with hammer until clutch is removedPN 931477A
Clutch Holding Wrench: PN 931477-A
2Slight galling or scoring of bore taper can usually be corrected by using tapered reamerPlace reamer in vise and lubricate the cutting edges with cutting oilClean clutch taper by manually rotating clutch clockwiseDo not ream taper more than required to remove galling or scoringNever use power tools to ream taper of drive clutch